Kick the Winter Blues

Is your heater giving you the cold shoulder? Here’s something that’ll get the sparks flying. Our 18-point Tune-Up includes a ‘no breakdown’ guarantee. Meaning, if your heater breaks down at any point this season, the service is free — that’s hot.

And for a limited time, it’s only $99. (Think of all the pumpkin spice lattes and hot cocoas you could buy with those savings!) Click below and take advantage of our special deal today.

Keep your furnace or air conditioner running at peak performance and lower your utility bills by taking advantage of our one-time, 18-point tune-up for your furnace or air conditioner. Our 18-point inspections include a 'no breakdown’ guarantee. Ask our technicians for details. Want to save even more money? Ask how to get two of these tune-ups a year with our Comfort Club!

18-Point Furnace Tune-Up

  1. Replace air filter with standard 1″ filter or clean
  2. Inspect for combustible material around furnace
  3. Thermostat – test for proper operation
  4. Ignition system – test for safe and proper operation
  5. Check for proper exhaust venting
  6. Test safety and control circuits
  7. Clean and inspect burners
  8. Inspect heat exchanger and clean if necessary
  9. Clean flame sensor or pilot
  10. Test capacitors
  11. Measure and adjust gas pressure
  12. Check for natural gas leaks
  13. Inspect combustion air vents
  14. Electrical wiring – inspect and tighten connections
  15. Blower motor – check amps and blower wheel
  16. Measure supply/return temperature differential
  17. Test for carbon monoxide around furnace and from air stream
  18. Check smoke detector and carbon monoxide detector operation

18-Point Air Conditioning Tune-Up

  1. Replace air filter with standard 1” filter or clean
  2. Blower motor – check amps and blower wheel
  3. Thermostat – test operation
  4. Inspect indoor coil – if accessible
  5. Condensate drain – blow out if accessible
  6. Inspect outdoor coil for damage or leaks
  7. Clean outdoor coil and remove debris
  8. Check refrigerant charge.
  9. Electrical disconnect box – inspect for proper rating and safety
  10. Electrical wiring – inspect and tighten connections
  11. Contractor – test and inspect for burned contacts
  12. Inspect electrical for exposed wiring
  13. Test capacitors
  14. Inspect fan blade
  15. Check service valves for proper operation
  16. Measure temperature differential 15 – 20 degrees
  17. Compressor - check amps and wiring connections
  18. Inspect duct work for energy loss